Product Description

GE RR7PBP - 20A SPST Remote Control Relay Switch (3 wires)

Product Overview:
The new GE RR7PBP maintained relay switch, with 3 low voltage leads, is an ideal replacement for discontinued GE relays designed for standard, unlighted switches. Compatible with vintage Sierra Electric and Bryant brand solenoid relays, this model has a split low-voltage (24V) coil for switching the line voltage contact between latched ON and OFF positions.

Key Features

• System:

  • GE RR7PBP (replacement for RR7)
  • 24 Volt AC system
   

• Specifications:

  • 20 Amp, 277 Volt with 5-pin yellow plug end
  • SPST (Single Pole Single Throw) maintained mechanical relay module
  • 6" wire leads, with a yellow plug
  • 1.5" (W) x 1.75" (D) x 2.5" (H)
  • 7/8" diameter cylinder
   

• Wire Leads:

  • One Red
  • One Black
  • One Blue
   

• Coil Details:

  • 21-30 VAC Class 2 momentary
  • Coil resistance: 75-85 Ohms
  • Designed to resist burnout
   

• Installation & Operation:

  • Operates in any position
  • Mounts in a standard 1/2" KO (.865" - .875" diameter) for 14 or 16 gauge material
  • Maximum ambient temperature: 60°C
   

• Replacement Compatibility:

  • Replaces discontinued GE models: RR2, RR3, RR5, RR7, RR7EZ
  • Replaces standard Bryant solenoid relays
  • Can replace 7601P Sierra relay and similar types
   

• Certifications:

  • UL Listed 508G IND. CONT. EQ.
  • cULus (Canadian and U.S. compliance)
   

Power Contact Latching

• 20A Tungsten at 125 VAC, 1/2 HP motor at 110-125 VAC
• 30A Ballast at 277 VAC, 1 1/2 HP motor at 277 VAC
• 30A Resistive at 277 VAC
• 20A Ballast at 347 VAC, 1 1/2 HP motor at 347 VAC
• 20A Resistive at 347 VAC

Wiring Tips

• For older relay replacements:

  • Red to Red
  • Black to Black
  • White/Blue to Blue

• The two screw terminals on the base function similarly, so the load/hot wires from the panel can connect to either one.

RR7EZ Note

• The RR7PBP replaces the RR7EZ (which had pre-attached connectors). Simply cut off the yellow plug and attach your own connections for installation.

3-Way Switch Setup

• Wire switches in parallel for a 3-way (or more) setup. Ensure all switches connect to the same relay.

Operation

• The split low-voltage (24V) coil moves the line voltage contact armature between ON and OFF latched positions.
• Do not use DC power with pilot or locator switches.
• Suitable for tungsten filament, ballast, resistive, and motor loads at full-rated capacity.